HYDRAULIC PRESS BRAKE

Standard features-accessories for basic model

• Frame from tested IS 2062 plates , rigidly as per IMTMA guideline

• Ram travel can be set within 0.01mm, repeatability _+0.05 mm

• Two cylinders drive ram thru levers connected by torsion tube

• Easy controls help set bend angle , stroke length  , slow –down point

• Ram tonnage adjustable from front for segmented –complex tools

• Front operated back gouge ,two fingers with vert , hori, micro setting

• Two sheet supports with inlaid scale , stop for gauging from front

• Dovetail guides with replaceable liners takes even side thrusts

• Optimal 3-speed stroke. Fast descend-slow pressing-fast return

• 3 cycles- Inch for set-up , Single for 1-off run , Auto for production

• Movable panel houses all controls, Up-Drown Food Switches

• Main drive motor , hydraulic , electrical controls of global brands

• Accessible power pack , neatly lablled wiring for trouble shooting

• Premium honed cylinders , hard chrome pistons , special seals

• Working pressure only 160bar , most hyd parts of higher rating

• Pivots with hardened parts , centralized hand lubrication system

• En – 9 punch (single/segmented),die block (not under warranty)

• Lifting chains for moving , rotating die block for change of Vee

• Operation manual ,Bending chart , (first fill of oil not in our scope)

• Better overload safely, Possibility to stop ram for faulty stroke.

• Small height –width ,silent operation permit install near offices

• Inching helps verify bend line before executing bending stroke

• Wide clear pass ,long stroke helps Bend corrugated/tall forms

• Higher tones gang punching may be possible by staggering tools

• Few moving parts , less, operating cost, good life

Leave a comment